When Ejecting Carbonless Paper Weighing 63 G/M 2 Or Less To Finisher/Booklet Finisher - Ricoh Pro C7500 Operator's Manual

1. Getting Started
When Ejecting Carbonless Paper Weighing 63 g/m
Booklet Finisher
When printing on carbonless paper weighing 63 g/m
tray that is provided with the finisher on the finisher shift tray.
• You cannot attach a banner support tray along with an extension output banner sheet tray
attached to the finisher Shift Tray 1.
• Depending on the brand of the paper being used, the paper may be ejected normally even when
the banner support tray is not attached.
• When the banner support tray is attached, output sheets may not be stacked neatly.
• If you switch the output tray to eject paper while specifying [Enable] on the [Settings] hub [Printer
Settings] [Settings of Output Tray] [Shift Tray Settings] [Unlimited paper output], and also
[Not stacked] in [Stack Jobs] when the banner support tray is attached, the output paper may be
stacked on the same output tray.
1. Press the [Suspend / Resume] key on finisher or booklet finisher, and then remove the
delivered paper.
page 30 "Removing Prints from Finisher /Booklet Finisher during Printing or When in Standby
State"
2. Pull out the extension tray on the finisher shift tray 1 or 2.
34
2
2
(17 lb. Bond) or less, set the banner support
D0CIPC1772
or Less to Finisher/