Table of Contents
Advertisement
If the appliance is not installed above an oven, a separator panel (not included)
must be installed in the compartment under the appliance.
ELECTRICAL WARNINGS
It must be possible to disconnect the appliance from the power supply by
unplugging it if plug is accessible, or by a multi-pole switch installed upstream of the
socket in accordance with the wiring rules and the appliance must be earthed in
conformity with national electrical safety standards.
Do not use extension leads, multiple sockets or adapters. The electrical
components must not be accessible to the user after installation. Do not use the
appliance when you are wet or barefoot. Do not operate this appliance if it has a
damaged power cable or plug, if it is not working properly, or if it has been damaged
or dropped.
If the supply cord is damaged, it must be replaced with an identical one by the
manufacturer, its service agent or similarly qualified persons in order to avoid a
hazard - risk of electric shock.
CLEANING AND MAINTENANCE
WARNING: Ensure that the appliance is switched off and disconnected from the
power supply before performing any maintenance operation; never use steam
cleaning equipment - risk of electric shock.
Do not use abrasive or corrosive products, chlorine-based cleaners or pan
scourers.
ENERGY SAVING TIPS
Make the most of your hot plate's residual heat by switching it off a few minutes
before you finish cooking. The base of your pot or pan should cover the hot plate
completely; a container that is smaller than the hot plate will cause energy to be
wasted.
Cover your pots and pans with tight-fitting lids while cooking and use as little water
as possible. Cooking with the lid off will greatly increase energy consumption.
Use only flat-bottomed pots and pans.
5
Advertisement
Table of Contents
