Whirlpool IWHH9050CC Health & Safety, Use & Care, Installation Manual And Online Warranty Registration Information page 19

Setting the timer to turn cooking zone off
1.Touch the heating zone selection control button to select
the cooking zone you wish to set timer for.
2.Touch the timer control button , the number in timer
indicator flashing.
3.Then adjust Timer setting
•Touch the timer control button once, the number of
single digit in timer indicator flashing, then adjust single
digit of minute minder setting by sliding the slider control.
•Press the timer control button again, the number of tens
digit in timer indicator flashing, then adjust tens digit of
minute minder setting by sliding the slider control.
Timer up
Note: By continuous touch the timer control button, the slider
works at below consequence: "Single Digit-Tens Digit-
Confirm Setting -Single Digit-..."
4.When the timer is set, it will begin to count down
immediately, the display will show the remaining time.
NOTE: The red dot next to power level indicator will
illuminate for those zones be set with timer. You can check
timer setting of different cooking zone which set with timer,
by active this cooking zone.
NOTE: If more than one heating zone has timer setting,
the timer indicator will show the lowest time. The red dot
next to power level indicator will flash.
5.When cooking timer expires, the corresponding
cooking zone will be switch off automatically.
Note: The default setting of minute minder and timer is 30 minutes.
Note: After adjusting, the setting in timer indicator will be flashing for 5 seconds
and then stop flashing, then the setting be confirmed.
Note: The minute minder and timer can be use at the same time, timer indicator
shows the lowest time setting. If the lowest setting is minute minder, the red dot
next to timer indicator will flash. If the lowest setting is timer setting, the red dot of
corresponding cooking zone power level indicator will flash.
Note: If indicator shows timer setting of cooking zone. To check minute minder
setting, press the timer control button , the indicator will show minute
reminder setting.
19