Table of Contents
Advertisement
Using your cooktop
To start cooking
1. After the cooktop be connected to electricity and power on.
Press and hold the ON/OFF
about 3 seconds till you hear a "beep" to turn the
cooktop on. Now the cooktop enters into Standby mode, all cooking
level and timer indicators show "-".
2. Place a suitable pan on the cooking zone you wish to use.
• Make sure the bottom of the pan and the surface of the
cooking zone are clean and dry.
3. Set heating level of cooking zone
Before adjusting the heating level, you need to touch
the heating zone selection control button to select and activate
the cooking zone you wish to use.
The cooking level indicator of the selected zone flashes when
being active, then you could adjust its heat level as below:
• adjust heat setting by sliding the slider control.
Notes:
1. After connect to electricity, when power on, the buzzer of cooktop beeps once, all
indicators light up for 1 second then go out.
2. When the cooktop is in Standby mode, the induction cooktop will auto turn off
when there is no action within 1 minute, follow with a beeping sound.
3. To turn on the cooktop, press the ON/OFF button and hold on for about 3
seconds. To turn if off, press the ON/OFF button.
4. The power level can be adjusted from 0 to 9, default setting is at level 5.
5. The cooking level indicator of the selected zone flashes when adjusting. The
setting is confirmed when the number flashes for 5 seconds and stops flashing.
To turn off cooktop
1. You can turn the cooking zone off by adjust heat setting to
level 0, which indicator shows"-".
2. You can also turn the whole cooktop off by touching the
ON/OFF
control button.
control button for
Power up
14
Advertisement
Table of Contents
