Additional Information; Led Indications; Regulatory Compliance For Class A Equipment - Net to Net Technologies AAM8000 User Manual

7.0 ADDITIONAL INFORMATION

7.1 LED Indications

LED
PWR (Power)
ADSL LK (Link)
ADSL RX
(Receiving)
ADSL TX
(Transmitting)

7.2 Regulatory Compliance for Class A Equipment

7.2.1 US Federal Communications Commission (FCC)
Note: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
Caution: Changes or modifications not expressly approved by the manufacturer could void the
user's authority to operate the equipment.
210-0000039 rev 07
State Indication
solid green unit is operational
solid green ADSL connection is
established
flashing ADSL connection is
green established and
active
no no ADSL connection
illumination
flashing ADSL activity
amber
solid amber heavy Rx traffic
no no activity
illumination
flashing ADSL activity
amber
solid amber heavy Tx traffic
no no activity
illumination
Additional Information
If the Power LED is not illuminated, it is unlikely
the AAM8000 is receiving power and none of the
LEDs will be illuminated.
An ADSL link exists and the port may be
transmitting but it has not received any data
from the remote ADSL modem within the last
second.
The port has received valid data from the remote
ADSL modem within the last second.
The port is receiving data from the remote ADSL
modem.
The port is receiving large amounts of data from
the remote ADSL modem.
A link may exist but the port is not receiving any
data from the remote ADSL modem.
The port is transmitting data to the remote ADSL
modem.
The port is transmitting large amounts of data to
the remote ADSL modem.
A link may exist but the port is not transmitting
any data to the remote ADSL modem.