Default Settings - Net to Net Technologies AAM8000 User Manual

3.0 DEFAULT SETTINGS

No configuration is necessary for the AAM8000 to operate at default settings.
CONFIGURATION
Port Mode
VPI/VCI Detect
Circ. ID (Circuit Identification) n/a
IP Range 1
IP Range 2
Speed_Up
Speed_Dn (Down)
Protocol
4.0 AAM8000 MANAGEMENT
Once the AAM8000 has been installed, operational mode, bandwidth and all other configurations are
software selectable. Dependent upon the MUM model installed in your DSLAM, the AAM8000 can be
configured via Command Line Interface (CLI), Simple Network Management Protocol (SNMP) and/or Net to
Net Technologies' web-based Network Management System (NMS). For further information regarding
AAM8000 management and configuration please refer to Net to Net Technologies' NMS Management User
Guide and/or CLI and SNMP Management User Guide.
4.1 Via NMS
Net to Net Technologies' Network Management System (NMS) is an embedded web server that
resides within the firmware of IP DSLAM MUMs (select models only). This web server maintains
statistical and configuration data for the AAM8000 and includes a scaled-down version of Simple
Network Management Protocol (SNMP v1.0).
N If your IP DSLAM is newly installed and has not yet been set up for management access, you must configure
OTE
the IP Address, Subnet Mask and Gateway (via either NMS or CLI) before you will be able to access data or
complete any other configurations. See the NMS Management User Guide or the CLI and SNMP Management
User Guide for initial configuration instructions.
4.1.1 Establish a Connection with the IP DSLAM MUM
Establish a connection with your IP DSLAM MUM either directly (through the Ethernet RJ45
MGMT Port on the MUM faceplate) or, if the system has been so configured, from a PC on your
local network. For direct connections, verify that the MGMT LNK LED on the MUM faceplate is
illuminated (indicating the connection has been established).
4.1.2 Launch a Web Browser
Launch a web browser on your PC such as Microsoft Internet Explorer (v4.0 or higher) or
Netscape Navigator (v4.0 or higher).
210-0000039 rev 07
DEFAULT
Adaptive
On
0.0.0.0 - 255.255.255.255
0.0.0.0 - 0.0.0.0
n/a (Adaptive Port Mode)
n/a (Adaptive Port Mode)
All
CONFIGURATION DEFAULT
Backbone-VLAN 0
VLAN 0 - 0
Pri (VLAN Priority) 0
Flood Upl (Uplink)
Frame Type 1483LLC
VPI 0
VCI 0
Standard Mode Multimode