Circuit Configuration; Data Storage; Additional Information - Net to Net Technologies SAM1000 User Manual

Management System Configuration Defaults
IP Addresses:
IPD12000 slot 13 192.168.254.252
IPD12000 slot 14 192.168.254.253
IPD4000 slot 5
SAM1000-12 Circuit Defaults
Circ. ID:
IP Range 1: 0.0.0.0 - 255.255.255.255
IP Range 2: 0.0.0.0 - 0.0.0.0
Speed:
Protocol:

Circuit Configuration

Circuit configurations for the SAM1000-12 are defined in the Management User Guide for IP
and Mini DSLAMs. Default settings may be altered via the Circuit Configuration window of Net
to Net's Network Management System (NMS).

Data Storage

Configuration backup is inherent in the SAM1000-12. Upon initial power up of the IP DSLAM,
the default parameters of the SAM1000-12 will remain in place unless changed through NMS.
Once changed, new configurations will automatically be recorded in the Random Access
Memory (RAM) of the SAM1000-12 and the Non-Volatile Random Access Memory (NVRAM) of
the MUM. While data stored in SAM1000-12 RAM will be erased if the unit loses power, data
stored within MUM NVRAM will remain intact (even if the unit loses power) unless deliberately
cleared or reconfigured.

ADDITIONAL INFORMATION

Speed
There are four bandwidth options for the SDSL link; default is 272 kbps. Distance capabilities
listed below assume the use of 26 American Wire Gauge (AWG) cable; connections made with
cable of a lesser gauge (e.g., 24 AWG) will link up at greater distances. The units may not link
up if the cable distance is greater than a particular bandwidth will support. Remote SDSL
modems determine line speed through their communication with the SAM1000-12.
210-0000011 rev03
Subnet Mask:
Default Gateway:
In-band Management: disabled
192.168.254.252 Uplink VLAN ID:
n/a
272 kbps
ALL
255.255.255.0
0.0.0.0
0
Backbone-VLAN: 0
VLAN: 0 - 0
Pri [Priority]: 0
Flood: Upl [Uplink]