Usb Ports - DFI CS650 User Manual

Internal I/O Connectors COM (Serial) Ports
X X
„ Internal COM Port Pin Assdignment
Standard RS232 with Power
Pin
RS232 (COM 2 only)
1 DCD- +12V
2 RD RD
3 TD TD
4 DTR- DTR-
5 GND GND
6 DSR- DSR-
7 RTS- RTS-
8 CTS- CTS-
9 RI- +5V
User's Manual | CS650
RS422 RS485
(COM 2 only) (COM 2 only)
RXD+ Data+
RXD- Data-
TXD+ N.C.
TXD- N.C.
GND GND
N.C. N.C.
N.C. N.C.
N.C. N.C.
N.C. N.C.
Internal I/O Connectors
X

USB Ports

„ USB 9/10 (left),
11/12 (right)
(USB 2.0)
1
2
10
„ USB 13 (USB 2.0)
vertical Type A
The USB device allows data exchange between your computer and a wide range of simultane-
ously accessible external Plug and Play peripherals.
In addition to the rear USB ports as introduced previously in this chapter, the system board is
equipped with five internal USB 2.0 ports and 2 USB 3.1 Gen 1 ports as illustrated above.
The internal USB pin headers may be connected to a card-edge bracket. Install the card-edge
bracket to an available slot at the rear of the system chassis and then insert the USB port
cables to a connector. The Part Number of the 20-pin USB 3.1 connector is 346-521081-200G.
Please contact our sales representatives for more information if the cable is to be customized.
BIOS Setting
Configure the onboard USB in the Advanced menu ("USB Configuration" submenu) of the BIOS.
Refer to chapter 3 for more information.
Wake-On-USB Keyboard/Mouse
The Wake-On-USB Keyboard/Mouse function allows you to use a USB keyboard or USB mouse
to wake up a system from the S state(s).
Note:
The pin headers for USB 2.0 ports (USB 11/12) can be optionally replaced by a
USB 2.0 Type A port by request.
Chapter 2
HARDWARE INSTALLATION
1
PWR
PWR RX-
RX- RX+
RX+ GND
GND TX-
TX- TX+
TX+ GND
D-
GND
D- D+
D+ 5V
11 10
„ USB 5/6 (USB 3.1 Gen 1)
24