Z6 Styling; General Characteristics - Electrolux EWM09311 Service Manual

14 Z6 STYLING

14.1 General characteristics

The EWM09311 / EWX13611 electronic control system consists of two circuit boards:
 Control/display board in a plastic casing fitted to
the control panel (the figure illustrates the
individual board and the board assembly
consisting of board, casing and diffuser).
 Main board, located at the rear of the appliance.
It powers the electrical components and receives
commands from the display board.
 Main board, positioned at the rear of the appliance.
It powers the electrical components and receives commands from the display board.
Main board EWX13611
Programme selector
Secondary selector
No. buttons
No. LEDs
Serial port
Power supply voltage
Washing type
Rinsing system
Motor
spin speed
Anti-unbalancing system
Water fill
Detergent dispenser
Control of water level in the tub
Door safety interlock
Heating element heat output
Temperature check
Technical Support - DMM

15 positions without main switch (incorporated in the circuit
board)

6 positions, only for version Z 5 (incorporated into the circuit
board)

maximum 5 (1 Spin/Temperature + 2 options + 1 start/pause + 1
delayed start)

Z5 Styling maximum 12 (11 green LEDs + 1 red LED).

Z6 Styling maximum 16 (15 green LEDs + 1 red LED)

DAAS-EAP communications protocol up to 230400 baud

220/240V

50/60 Hz (configurable)

traditional

traditional

Collector, with tachometric generator (Universal)
600 ÷1,400 rpm


AGS

1 solenoid valve with 1 inlet – 2 outlets

2 compartments: wash, conditioners

Electronic/analogue pressure switch

Traditional (with PTC)

1750W with thermal fuse incorporated

NTC probe incorporated in the heating element
49/124
Main board EWM09311
599 75 58-67 Rev.04