Electrolux EWM09311 Service Manual page 37

Selector
position
TC 3-2
11
- Reading/Deleting the last alarm
TC 4
TC 3-2
- The LEDs, groups of symbols
in the LCD screen and the
backlight of the display are
12 turned on in sequence
÷
- Touch a sensor to turn on the
TC 4
14 group of icons in the LCD
screen or the corresponding
LED and the buzzer sounds at
the same time
(*) In most cases, this time is sufficient to check the heating. However, the time can be increased by repeating the phase without draining the
water: pass for a moment to a different phase of the diagnostic cycle and then back to the heating control phase (if the temperature is higher
than 80°C, heating does not take place).
(**) The check at the maximum speed occurs without control of the A.G.S. and no garments must be inside the appliance.
Technical Support - DMM
Components activated Working conditions
-----
Always active
37/124
Function tested LCD display
----
User interface
functioning
599 75 58-67 Rev.04