Table of Contents
Advertisement
Available languages
Available languages
Vented Models:
Vent Clamps, elbows, and vent work
Parts Needed (not supplied with dryer):
Additional parts may be required, depending on your installation.
See "Electrical Requirements" and "Venting Requirements" before
purchasing parts.
available for purchase from the dealer from whom you purchased
Guide for service contact information.
Available Accessories:
Accessories and replacement parts are available for your model.
Location Requirements
Explosion Hazard
Keep flammable materials and vapors, such a s gasoline,
away from dryer.
.
Place dryer at least 18 inches (460 mm) above the floor
for a garage installation.
Failure t o d o s o can result i n death, explosion, o r fire.
Check code requirements. Some codes limit, or do not permit,
installing dryer in garages, closets, mobile homes, or sleeping
quarters. Contact your local building inspector.
installation. See "Venting Requirements."
located within 2 ft (610 mm) of either side of dryer. See
"Electrical Requirements."
H A sturdy floor to support dryer weight of 200 Ibs (90.7 kg).
-
Also, consider the combined weight of the companion
E For steam dryers: Cold water faucets located within
4 ft (1.2 m) of the water fill valves, and water pressure of
20-120 psi (138-827 kPa). You may use the water supply for
may need to purchase).
entire
dryer. If the slope is greater than 1" (25 mm), install
properly and automatic sensor cycles may not operate
correctly.
to bottom of the dryer.
will be exposed to water and/or weather.
IMPORTANT: Do not operate dryer at temperatures below
'end of automatic sensor cycles, resulting
in
longer drying times.
Installation clearances:
For each arrangement, consider allowing more space for ease of
installation and servicing, spacing for companion appliances, and
large enough to allow the dryer door to fully open. Add spacing on
used, top and bottom air openings are required. Louvered doors
with equivalent ventilation openings can be used.
All dimensions show recommended and minimum spacing
allowed.
installation and servicing.
moldings, dryer venting, and drain system.
E For closet installation with a door, minimum ventilation
vented models. Louvered doors with equivalent ventilation
openings are acceptable.
Recommended installation clearances (dryer
only):
—
1 4 " (maximum) —
—
(356 m m
O
3 "
(76 m m )
b a w
_
~ ~
6"/0"*
ES
= .
(152 mm/0 mm) = >
(25 h o
m m )
*Recommended/Minimum spacing
Vented Models:
Vent Clamps, elbows, and vent work
Parts Needed (not supplied with dryer):
Additional parts may be required, depending on your installation.
installation and servicing.
—
bm.
Advertisement
Table of Contents
