Whirlpool YWED5050LW Owner's Manual page 13

6. Connect remaining wires
o o
5.
*
Connect remaining wires under outer terminal block screws.
'
Tighten screws. Insert tab of terminal block cover into slot of
dryer rear panel. Secure cover with hold-down screw. Now,
3-Wire Power Supply Connection
IMPORTANT: Use where local codes permit connecting cabinet-
1 L |
Es
A. 3-wire receptacie E. 3/4" (19 mm) UL-listed
(NEMA type 10-30 R) strain relief
C. Neutralprong G. Neutral (white or center
D. Spade terminals with wire}
upturned ends
3. Remove center screw
a . 2.
— e
4. Connect neutral wire
— — — O
Connect neutral wire (white or center) (C) of power supply
cord under center terminal block screw (B). Tighten screw.
Connect remaining wires
a
+
e
p A
Connect remaining wires under outer terminal block screws.
Tighten screws. Insert tab
of
terminal block cover into slot of
dryer rear panel. Secure cover with hold-down screw. Now,
go to "Venting Requirements."
Direct Wire Connection
Direct wire strain relief
Attach direct wire strain relief
Unscrew the removable conduit connector (A) and any
screws from a 3/4" (19 mm) UL-listed strain relief (UL marking
on strain relief). Put the threaded section of the strain relief
Reaching inside the terminal block opening, screw the
removable conduit connector (A) onto the strain relief threads
—
=)
|
e r
i p a r
g t »
Put direct wire cable through the strain relief. The strain relief
horizontal position. Tighten strain relief screw against the
direct wire cable.
For 4-wire Direct Wire Connection, continue t o step 3.
"4-Wire
Direct Wire Connection."
For 3-wire Direct Wire Connection, continue t o step 3.
3-wire direct wire connection: Go to
"3-Wire Direct Wire Connection."
13
6. «Connect remaining wires
[ a s
—
m s
— —
Connect remaining wires under outer terminal block screws.
Tighten screws. Insert tab terminal block cover into slot of
dryer rear panel. Secure cover with hold-down screw. Now,
go to "Venting Reguirements."
Direct wire strain relief
*
— —
Unscrew the removable conduit connector (A) and any
screws from a 3/4" (19 mm) UL-listed strain relief (UL marking
on strain relief). Put the threaded section of the strain relief
a i
Direct Wire Connection."
For 3-wire Direct Wire Connection, continue t o step 3.
3-wire direct wire connection: G o to
"3-Wire Direct Wire Connection."
13