Whirlpool YWED5050LW Owner's Manual page 11

c c
Excessive Weight Hazard
For power supply cord, use a new U L listed 30 A power
supply cord.
For direct wire, use 10 gauge copper wire.
Disconnect power before making electrical connections.
Connect neutral wire (white o r center wire) t o center
terminal (silver).
Connect ground wire (green o r bare wire) t o green
ground connector.
Connect remaining 2 supply wires t o remaining 2
terminals (gold).
To avoid damaging floor, use a large flat piece of cardboard Securely tighten all electrical connections.
Firmly grasp dryer body (not console panel) and gentiy lay e t o d o s o can result
i n
death, fire, o r electrical
dryer down on cardboard.
NOTE: Residual water from factory testing may drain when
dryer is laying on its side.
2. Screw i n leveling legs 2. Remove terminal block cover
NOTE: Your terminal block cover may be in a different
location.
1 . Prepare dryer for leveling legs
1. Disconnect power
leg holes until bottom of foot is approximately 1/2" (13 mm) to
11/2" (38 mm) from bottom of the dryer.
tuming legs until diamond marking is no longer visible.
dryer on the corner posts until it is close to its final location.
Leave enough room to connect the exhaust vent.
11
Use two o r more people t o move and install o r uninstall
c e
|
|