Pre-Programmed Memory Locations - Johannus Studio 260 User Manual

Wind Distribution
The operation of the wind supply can be set with the 'Wind Distribution' option.
There is a setting for the Chorus Off, where the effect of detuning is less strong by
default (this is visible in the menu as a higher percentage of Wind Distribution). In
addition, there is a setting for the Chorus On, where the effect of detuning is
stronger (this is visible in the menu as a lower percentage of Wind Distribution).
For menu selection details, see
RO: Reeds Off
Reeds off is a function to switch off all reed stops simultaneously. As long as this
piston is pressed, no reed stops can be activated. When this function is switched
off, the reed stops that were on are activated again. Use the RO piston to activate
the Reeds Off function.
Panflute (PANFL.), Trumpet (TRUMP.):
Use the PANFL. piston and/or TRUMP. piston to activate these orchestral sounds.
Assignment of Panflute and Trumpet sounds to a specific manual
Press and hold the SET (or ENTER) piston and PANFL piston simultaneously to
activate the assignment option for the Panflute orchestral sound. After that, press
a key on one of the manuals (Choir, Great, or Swell) to assign the Panflute to a
specific manual. During this action, the display shows the assigned instrument.
The Trumpet can be assigned in the same way: In this case press the SET and the
TRUMP. pistons simultaneously and thereafter a random key on one of the
manuals.
0: Recall / Reset function
The 0 piston cancels registration in two ways:
1. A short press on the 0 piston: only the last change is cancelled.
2. A long press on the 0 piston: cancels all stops, registration.
Keyboard Transfer, optional
Keyboard Transfer allows you to switch between the manuals of the Choir and the
Great. When Keyboard Transfer is active, manual 1 becomes the Great manual,
and manual 2 becomes the Choir manual. Activate Keyboard Transfer by using the
menu, see § 5.9.5.
4.9

Pre-programmed memory locations

Pre-programmed memory locations are available by operating pistons PP to T and
PL. These seven memory locations have factory settings (presets) appropriate for
the quiet pianissimo to the loud tutti and the classic plenum.
Calling up a pre-programmed memory location:
Press a pre-programmed memory location (PP-T or PL). The active stops light up.
Programming a pre-programmed memory location:
The current setting of the pre-programmed memory location will be lost.
User Manual Studio 260 / 360 / P-360
.
§ 5.9.6
:
(Studio 360, P-360 only)
26