Paradyne 3100 Series Installation Instructions Manual page 9

Attaching the Unit to the Wall-Mount/Rack-Mount Bracket
To attach the unit to the Wall-Mount/Rack-Mount Bracket, use the following procedure:
1. Make sure there are no twists in the straps, then slip the open end of each strap through the upper strap
loop starting from the bottom. Slip the strap in approximately one inch. Leave enough slack to slide the
unit into the bracket. Refer to Figure 1.
2. Slide the front end of the unit into the bracket, making sure the front panel is visible, until the entire unit
fits snugly between the lips on either side of the bracket.
3. Tighten the straps to secure the unit into place by pulling up or out on each strap and pressing the excess
portion of the strap in contact with the length of the strap holding the unit in place.
Wall-Mount/Rack-Mount Adapter installation is now complete.
9