Paradyne 3100 Series Installation Instructions Manual page 3

Attaching the Straps to the Wall-Mount/Rack-Mount Bracket
To attach the straps to the Wall-Mount/Rack-Mount Bracket, use the following procedure:
1. Hold the strap with the smooth side down. Starting from the inside, slip one end of the strap through the
outer lower strap loop of the Wall-Mount/Rack-Mount Bracket. Slip the strap in approximately one inch.
Refer to Figure 1.
2. Secure the strap in place by pressing the one-inch segment of the strap in contact with the remaining
length of the strap.
3. If you are mounting a unit with expanded housing, skip to Step 4. If you are mounting a base unit, make
sure there are no twists in the strap, then slip the open end of the strap through the inner lower strap loop.
Remove any slack between the outer lower strap loop and the inner lower strap loop. Refer to Figure 1.
4. Allow the open end of the strap to hang freely. This enables you to attach the Wall-Mount/Rack-Mount
Bracket to the wall, shelf, or cabinet without obstruction from the strap.
5. Repeat Steps 1–4 for the remaining strap.
You are now ready to attach the Wall-Mount/Rack-Mount Bracket to a wall, equipment shelf, or equipment
cabinet.
Figure 1. Wall-Mount/Rack-Mount Bracket with Straps Attached
3