Marantz SC-11S1 User Manual page 33

INPUT SELECTOR
Knob
Note:
If the 10 number is set to a number other than "0", this unit
cannot be used for standalone operation.
The 10 number of the unit appears on the display for about 3
seconds after the power is activated.
If using this unit by itself as a stereo amplifier, set the 10 number
to "0" (Default setting is "0").
[~_H_O_W_T_O_U_S_E_A_N_D_S_E_T_F_E_A_:r_U_R_E_S ---------~]
I
( HOW TO SET 10 NUMBERS
DISPLAY button
,....-..l==;=c]===~===;;;:;r=6=;=====---,
e
Q
0
L..-+'r"===J_e...l..-_o_ _
?
0---l._(:)~==T----J
POWER ON/OFF Switch
I [)
Lo:
::..:
Set 10 numbers as follows.
1.
While pressing and holding the DISPLAY button, press the
POWER ON/OFF switch.
2.
Turn the INPUT SELECTOR knob to the desired 10
number.
When multiple SC-11 S1 s are connected, a unique 10 number
must be set of each one in order to distinguish between
them.
The unit that centrally controls the other units takes 10 1.
The unit with 101 is called the "Master". The other units that
synchronize with the master are called "slaves" and take IDs
I [::
:.':
::..=
"2" "'- "4".
T f"-:
oj
l. ;....
.I.
After finishing setting the 10 number, turn power to the unit
OFF.
The setting is stored in memory and becomes active the next
time power to the unit is switched ON.
27