Marantz SC-11S1 User Manual page 32

This function can be applied to various usages such as
complete bi-amp with 2 SC-11 S1 s (page. 14), and 5.1ch multi-
channel with 3 SC-11 S1 s (page. 16).
Note:
The SC-11 S1 EC.B.S. function is only valid between the
same SC-11 S1 models. This function may not operate
correctly if other Marantz models (PM-11 S1, PM-15S1 etc)
are connected.
a:rc::::C::IIDlIIIIIllIIIII[]1I
i====~\\\====[[i 1i1IIl1i1i1III[!!!I~
• Stereo miniplug
~
stereo miniplug connecting cable
EC.B.S. (Floating Control Bus System) is a communication
system that connects up to four SC-11 S1s over a dedicated
bus line so as to enable synchronized operations amongst
them via 2-way data communications.
Prepare the correct number of portable audio connection
cables for the number of units to be connected. Either of the
following types of connection cables are adequate.
• Monaural miniplug
~
monaural miniplug connecting
cable
I
[~_H_O_W_T_O_U_S_E_A_N_D_SE_T_FE_A_:r_U_R_E_S ------~]
( F.e.B.S.
J
The figure below shows an example of four SC-11 S 1s
. connected by EC.B.S. The top unit is the master unit with 10
1 and controls the three slave units with 10 2-4. When the
master unit is operated, the input source, volume level,
An
feature, display and tone control ON/OFF feature of the slave
units are operated in sync with the master unit.
~IllIlIlI[Jll!IIiDli===~\}:\====OiIIllIllilllIIll!li~
Note:
00 not use connecting cables that contain resistance.
To turn the power of mUltiple F.C.B.S.-connected units ON/OFF, switch the power ON in order of lowest to highest 10
number, and switch the power OFF in order of highest to lowest 10 number.
•
•
•
102 Slave
101 Master
SC-llSl
• • •
103 Slave
~
SC-llSl
~ t
• •
104 Slave
@@
SC·11S1
SC·llSl
26