Editing An Existing Static Route; Deleting An Existing Static Route; Enabling Or Disabling An Existing Static Route - Check Point QUANTUM SPARK 1500 Administration Manual

Editing an Existing Static Route

Procedure
1. From the left navigation panel, click Device.
2. In the Advanced Routing section, click the Routing Table page.
3. In the routing table, click the route.
4. Above the routing table, click Edit.
5. Change the configuration.
6. Click Apply.

Deleting an Existing Static Route

Procedure
1. From the left navigation panel, click Device.
2. In the Advanced Routing section, click the Routing Table page.
3. In the routing table, click the route.
4. Above the routing table, click Delete.

Enabling or Disabling an Existing Static Route

Procedure
1. From the left navigation panel, click Device.
2. In the Advanced Routing section, click the Routing Table page.
3. In the routing table, click the route.
4. Above the routing table, click Enable or Disable.
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Centrally Managed Administration Guide
Configuring the Routing Table
| 218