User Authentication - Check Point QUANTUM SPARK 1500 Administration Manual

3. The Selected Network Objects window shows the selected objects. To remove
an object from the list, click the x next to it.
4. To filter the object list, enter the filter value. The list shows the objects that match
the filter.
5. If necessary, click New to add new objects to the list. For information on how to
create a new object, see the Users &Objects > Network Objects page.
6. Click Apply
The added objects are excluded from the Hotspot.

User Authentication

In the Access section of the page, you can configure if authentication is required and allow
access to all users or to a specified user group (Active Directory, RADIUS or local).
To require user authentication:
1. Select the Require Authentication checkbox.
2. You can allow access to All users or to a Specific user group.
3. If you selected Specific user group, enter the group's name in the text box.
4. Click Apply
Any user/user group that browses from configured interfaces is redirected to the Check
Point Hotspot portal and must enter authentication credentials.
To configure the session timeout:
1. In Session timeout, enter the number of minutes that defines how long a user stays
logged in to the session before it is ends.
2. Click Apply
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Centrally Managed Administration Guide
Configuring a Hotspot
| 162