Table of Contents
Advertisement
FIRE, EXPLOSION AND ELECTRIC SHOCK HAZARD
Improper grounding, poor air ventilation, open flames, or sparks can cause a hazardous condition
and result in fire, explosion, or electric shock and other serious injury.
D Ground the equipment, the object being dispensed to, and all other electrically conductive
objects in the dispense area. See Ground the System on page 10.
D Do not use this equipment with flammable fluids.
D Do not stop or deflect fluid leaks with your hand, body, glove, or rag.
D Keep the dispense area free of debris, including solvent, rags, and gasoline.
D If there is any static sparking or you feel an electric shock while using the equipment, stop dis-
pensing immediately. Do not use the equipment until you have identified and and corrected
the problem.
D Provide fresh air ventilation to avoid the buildup of flammable fumes from solvent or material.
D Do not smoke in the dispense area.
D Extinguish all open flames or pilot lights in the dispense area.
D Make sure all electrical equipment is installed and operated in compliance with applicable
codes.
D Make sure power is disconnected when servicing and repairing equipment.
D Have any checks, installation, or service to electrical equipment performed by a qualified electri-
cian only.
D Never exceed the maximum wattage of the supply unit. See the wiring diagrams in this manual
for more information.
D Only use hoses that have a maximum wattage less than an equal to 1250 watts. Using hoses
with higher maximum wattage could create a runaway temperature condition.
D Keep a fire extinguisher in the work area.
MOVING PARTS HAZARD
Moving parts, such as the ram plate and pump inlet, can pinch or amputate your fingers.
D Moving equipment parts can cause personal injury, including severing of hands or fingers.
Make sure all personnel are clear of moving parts before operating the equipment.
D Keep clear of all moving parts when starting or operating the equipment.
D Keep hands and fingers away from the priming piston during operation and whenever the pump
is charged with air.
D Keep clear of the ram plate, pump fluid inlet, and lip of the fluid container when raising or lower-
ing the ram.
WARNING
309213
5
Advertisement
Table of Contents
