Installing The Air Distributor Assembly; Installing The Remote Control Holder; Testing The System - Houghton Webasto Cool Top Trail 20 Operating And Installation Instructions

5.15 Installing the air distributor
assembly
1. Attach the air distributor (1) to the air distributor mounting
bracket (3) by engaging the two parts.
– You will hear four clicks of the latches (2) when the air
distributor (1) and the mounting bracket (3) connect to-
gether.
Fig. 27 Attaching the air distributor assembly to the mounting bracket
2. Fix the air distributor (1) on the air distributor mounting
bracket with four ST4.2 * 19 pan head screws (2).
Fig. 28 Fixing the air distributor assembly to the mounting bracket
– The following step is optional. The purpose of this step
is to close a potential gap between the air distributor
and the ceiling of the vehicle by using 4 countersunk
screws.
– To install these screws:
3. Attach the air distributor (1) to the ceiling using 4 counter-
sunk screws (2).
9039408E_OI-II_Cool Top Trail 20-24
Fig. 29 Fixing the air distributor to the ceiling
4. Install the air filters (2) as illustrated below:
Fig. 30 Installing the air filters
5.16 Installing the remote control
holder
1. Find a convenient location to install the remote control
holder (1).
2. Use the 2 countersunk screws (2) to secure the holder.
Fig. 31 Remote control holder
5.17

Testing the system

l Test all air conditioner functions as described in chapter 6,
"Operating Instructions" on page 12.
l Make sure that the condensate outlets are clear after in-
stalling the outdoor unit.
l Enter the new vehicle height and weight in the vehicle doc-
uments if required.
l Hand this document over to the new vehicle owner.
Installation instructions | 5
11 / 155