Table of Contents
Advertisement
–
Manually press the brake caliper toward the brake disc to push
back the brake piston. Ensure that brake fluid does not flow
out of the brake fluid reservoir; extract some if necessary.
Info
Make sure that you do not press the brake caliper
against the spokes when pushing back the brake piston.
–
Remove cotter pins
brake linings.
S05524-10
–
Clean the brake caliper and the brake caliper bracket.
–
Check that spring plate
sliding plate
rectly.
Info
The arrow on the spring plate points in the direction of
rotation of the brake disc.
S05525-10
–
Insert the new brake linings, insert pin
3
pins
.
Info
Always change the brake linings in pairs.
Make sure that decoupling plate
piston side brake lining.
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
S05526-10
point.
–
Correct brake fluid level to marking
Brake fluid DOT 4 / DOT 5.1 (
–
Mount and tighten screw cap
O-ring.
Info
Use water to immediately clean up any brake fluid that
has overflowed or spilled.
W00090-11
Finishing work
–
Install the frame protector. (
3
4
, pull out pin
, and remove the
5
in the brake caliper and brake pad
6
in the brake caliper bracket are seated cor-
4
7
A
.
p. 138)
1
with membrane
p. 52)
BRAKE SYSTEM 12
, and mount cotter
is mounted on the
2
and the
93
Advertisement
Table of Contents
