Table of Contents
Advertisement
●
If the fuel door does not re-latch upon
closure, push the fuel door release button
again to reset the latch. If pushing the fuel
door release button a second time does
not correct the problem, take the vehicle
to an authorized dealer for service.
NOTE:
In certain cold conditions, ice may prevent
the fuel door from opening. If this occurs,
lightly push on the fuel door to break the ice
buildup and re-release the fuel door using
the inside release button. Do not pry on the
door.
4.
Remove the fuel filler cap and insert the
nozzle and fill the vehicle with fuel; when the
fuel nozzle "clicks" or shuts off the fuel tank
is full.
5.
Remove the fuel nozzle, replace the fuel filler
cap by turning until you hear one click, and
then close the fuel door.
NOTE:
●
Tighten the fuel filler cap about a quarter
turn until you hear one click. This is
an indication that the cap is properly
tightened.
●
After the click, pull on the cap at the
handle to verify it is secure and fastened.
EXTERIOR
42
●
If it is loose, and not secured to the filler
tube, reinstall and tighten again about a
quarter turn until you hear the click.
●
Verify the cap tether is not pinched
between the cap and filler tube.
●
If the fuel filler cap is not tightened
properly, the yellow Loose Fuel Filler Cap
Warning Light and the "Check Fuel Cap"
message will appear in the instrument
cluster.
●
Be sure the cap is tightened every time
the vehicle is refueled.
WARNING!
●
Never have any smoking materials lit in or
near the vehicle when the fuel door is open
or the tank is being filled.
●
Never add fuel when the engine is running.
This is in violation of most state and
federal fire regulations and may cause the
Malfunction Indicator Light (MIL) to turn on.
●
A fire may result if fuel is pumped into a
portable container that is inside of a vehicle.
You could be burned. Always place fuel
containers on the ground while filling.
CAUTION!
To avoid fuel spillage and overfilling, do not
"top off" the fuel tank after filling.
Emergency Fuel Door Release
1.
Place the vehicle's ignition in the RUN
position (Propulsion System Active (PSA)
not active).
NOTE:
If this is not performed, then the tank
vent valve will not open. This will result in
premature fuel pump shutoffs.
2.
Access the rear quarter trim panel in the
cargo area on the left side of the vehicle.
Release Cap Location
Advertisement
Table of Contents
