(EU/UK/AR/CN)
–
Mount reflector
washers
–
Position the license plate bracket on the license plate sup-
port.
–
Mount and tighten screws
Guideline
Screw, license
plate holder
–
Carefully loosen and remove the rear tension belt.
Info
An assistant prevents the motorcycle from falling over.
–
Carefully loosen and remove the tension belts around the lower
triple clamp.
The vehicle is released at the front.
–
Together with an assistant, take the vehicle off the pallet.
W00274-10
–
Remove the front rider's seat. (
–
Remove spare key and KEYCODECARD from under the seat and
keep in a safe place for the handover.
–
Charge the 12-V battery. (
Guideline
The 12-V battery must be fully charged before it is handed
over to the customer.
Info
F02143-01
The first charging process may take longer with a new
12-V battery.
–
Remove protection cap
–
Plug in the plug
–
Mount protection cap
W00275-10
Info
The tool set is located in the storage compartment under
the seat.
T04547-01
3
with rubber bushings
5
on the license plate holder
7
.
M5
5 Nm (3.7 lbf ft)
p. 10)
p. 16)
8
.
9
of the starter relay.
8
.
SETUP 2
4
and tension
6
.
Loctite
®
243™
7