KTM 790 ADVENTURE 2024 Setup Instructions page 8

2 SETUP
6
Guideline
Screw for throttle
grip
Screw, combination
switch, right
Info
Pay attention to the markings on the handlebar.
Make sure the cables and wiring are positioned cor-
rectly.
–
Tie the cables and wires together with the rubber straps sup-
plied.
–
Check the throttle grip for smooth operation.
–
Position the clutch assembly on the handlebar.
Info
Pay attention to the markings on the handlebar.
–
Position the clutch assembly clamp on the handlebar.
–
Mount and tighten screws
Guideline
Screw, clutch assem-
F02132-10
bly
–
Tighten all the screws on the controls on the left half of the
handlebar.
Guideline
Screw, fixed grip, left
Screw, combination
switch, left
Info
Pay attention to the markings on the handlebar.
Make sure the cables and wiring are positioned cor-
rectly.
–
Tie the cables and wires together with the rubber straps sup-
plied.
–
Mount and tighten the rear mirror on both sides.
F02144-01
M5 3.5 Nm
(2.58 lbf ft)
M5 5 Nm (3.7 lbf ft)
2
.
M6 5 Nm (3.7 lbf ft)
M4 3 Nm (2.2 lbf ft)
M5 2 Nm (1.5 lbf ft)