Advertisement
2 SETUP
4
–
Roll down the film at the sides.
Info
To avoid damaging the motorcycle during unpacking,
leave the other films on the vehicle until you have fin-
ished work on the vehicle.
–
Remove the separate enclosure and unpack it. Check the sepa-
rate enclosure for completeness.
F02126-01
Info
The procedure for missing components is described in
the Customer Service Manual.
–
Check the vehicle for transport damage.
Info
The procedure in the event of transport damage is
described in the Customer Service Manual.
–
Remove the cable tie. Place the handlebar at the front.
–
Remove the clutch and the brake assembly from the transport
holder.
–
Remove the screws from the handlebar clamps. Take off the
handlebar clamps and transport holder.
Warning
Danger of accidents A repaired handlebar poses a
safety risk.
If the handlebar is bent or straightened, the mate-
rial becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged
or bent.
F02128-10
–
Unpack handlebar and position.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position the handlebar clamps. Mount and tighten the screws
evenly.
Guideline
Screw, handlebar
clamp
Markings
Handlebar scale markings
between the handlebar clamps.
Info
Keep the installed gap widths equal when tightening.
M8
20 Nm (14.8 lbf ft)
A
face the rear.
B
are located centrally
Advertisement
