Yamaha PLG150-AN Owner's Manual page 89

Extract AN Bulk Dump Data
• The following information pertains only to the Plug-in Editor.
This is used for importing the AN voice data contained in host application sequence
data to the AN Expert Editor. Specify the range (Start and End points) from which you
want to extract the settings. All current voice settings will be replaced by the extracted
data. This allows you to check what bulk data (voice and/or pattern) has been inserted
to the song; also, once you've extracted the data, you can
file. This function has no effect if there is no AN voice data in the specified range.
Keyboard shortcut: [Alt], [U], [E]
• "Extract AN Bulk Dump Data" can also be selected from the toolbar.
• Start
Measure / Beat / Clock
This determines the beginning point in the track from which the AN bulk dump data and
AN parameters will be extracted. You can specify the Measure (Meas), Beat, and Clock.
• End
Measure / Beat / Clock
This determines the end point in the track from which the AN bulk dump data and AN
parameters will be extracted. You can specify the Measure (Meas), Beat, and Clock.
• OK
Click this to extract the parameters at the specified location.
• Cancel
Click this to abort the operation.
Setup Menus /
Saving data to an AN Expert
89
Extract AN Bulk Dump Data