Yamaha PLG150-AN Owner's Manual page 3

Operations
Assigning the PLG150-AN to a Part
• The following information pertains only to the Plug-in Editor.
In order to play and edit the PLG150-AN, the AN voice must be assigned to a Part on
the tone generator/sound card. This can be done from two separate menus on the AN
Expert Editor: the initial
whenever you start the AN Expert Editor) and
I Select AN Part Pop-up Menu.......................................
• [Cancel] button may not be available depending on the editor you use.
z Select the desired Part.
The Select AN Part pop-up menu appears when you first call up the AN Expert Edi-
tor. Select the desired Part from the Part combo box.
• When using a Modular Synthesis Plug-in System "mother" device, the Part assignment
depends on which mode is used — Voice or Performance — and also on whether the PLG150-
AN board is installed/assigned to PLG1 or PLG2, as described below.
When using the Voice mode:
When using the Performance (Multi) mode:
x Click "OK."
• Click "Details" to call up the
Select AN Part Pop-up Menu
Set the Part to "1" (no matter what the PLG1 or PLG2 assignment is).
If the PLG150-AN board is assigned to PLG1, set the Part to "16."
If the PLG150-AN board is assigned to PLG2, set the Part to "15."
AN Expert Editor Setup
(which appears automatically
AN Expert Editor Setup.
menu for making more detailed settings.
3