Yamaha PLG150-AN Owner's Manual page 43

An expert editor

Hide thumbs Also See for PLG150-AN:

Table of Contents

• AEG RELEASE (Amplitude EG Release Time)

Range: 0 ... 127

This determines the Release Time of the AEG, or how long the sound sustains after a

note is released. Higher values increase the Release time. (See illustration below.)

DIST (Distortion) / EQ Block

The Distortion and EQ parameters give you further sonic control over the AN voice, let-

ting you apply and adjust distortion, and make detailed equalization settings.

•

DIST / EQ DETAIL Page

• DIST DRIVE (Distortion Drive)

Range: 0 ... 100

This determines the amount of distortion "drive" for the guitar ampliﬁer simulation effect

block. The higher the value, the greater the degree of distortion in the sound.

• DIST DRY/WET (Distortion Dry/Wet Balance)

Range: D63>W ... D=W ... D<63

This determines the level balance of the unprocessed (dry) original sound of the voice,

and the distortion processed (wet) sound. A setting of D=W results in an equal balance

of dry and wet sound. (In the display, "D" indicates "dry," and "W" indicates "wet.")

• EQ LO (Low Frequency Gain)

Range: -12 ... +12 (dB)

This determines the gain or level of the low frequency band. Positive values boost the

level of the frequency and negative values attenuate it. (The speciﬁc frequency to be

adjusted can be set with the

Parameters /

Low

Freq.

parameter in the DETAIL page.)

AN Expert Editor Main Window

Table of Contents