Related Manuals for Feider Machines FGHI7000R
Summary of Contents for Feider Machines FGHI7000R
- Page 1 ORIGINAL INSTRUCTIONS >EN PETROL INVERTER GENERATOR FGHI7000R USER GUIDE CAUTION: Read this manual before using this machine!
-
Page 2: Table Of Contents
CONTENTS 1. SAFETY INSTRUCTIONS........................... 3 2. QUICK START............................... 7 3. SAFETY LABEL POSITION..........................9 4. PARTS IDENTIFICATION..........................10 5. CHECK BEFORE OPERATION........................10 6. START THE ENGINE............................13 7. OPERATING THE GENERATOR........................15 8. SHUT OFF THE ENGINE..........................19 9. MAINTENANCE..............................20 10. -
Page 3: Safety Instructions
1. SAFETY INSTRUCTIONS WARNING 1. Attention! Exhaust gases are toxic. Do not operate the generator in a room without ventilation system! 2. Children should be protected by keeping them at a safe distance from the generator set! 3. Refilling of the generating sets are not allowed during the operation! 4. - Page 4 Keep the fuel filter clean, and change the oil of the motor regularly. Periodically check the installation of the connections and the tightness of the fixations, re-tightening them if necessary. Clean the components of the air filter periodically, and replace the air filter when necessary. ...
- Page 5 Always stop the motor of the generator when filling it with fuel. Never fill the fuel tank while smoking or near a naked flame. Make sure you don’t spill fuel on the motor and the exhaust grille of the generator during filling with fuel.
- Page 6 Symbol Attention! Please read the manual carefully before using the unit! Conforms to relevant safety standards Do not dispose of old appliances with domestic rubbish . Guaranteed sound power level Ground connection Fill in engine oil It is forbidden to run the generator in an enclosed room because exhaust emissions can lead humans or animals to coma to death.
-
Page 7: Quick Start
2. QUICK START WARNING Only use outdoors. The generator emits carbon monoxide, a toxic colorless and odorless gas that can cause death or serious injury. Ensure that the generator is placed horizontally. Never work in the rain, snow or other humid environment. ... - Page 8 Electric start: Turn the fuel switch to start position. Insert the ignition key and turn to “ON” position. Turn the ignition key to "START" position, do not loosen until the generator is started. Turn the key no more than 10 seconds. If fail to start, loosen the key and wait 10 seconds to try one more time.
-
Page 9: Safety Label Position
WARNING This symbol is displayed if you do not follow the correct operation of the manual, it will lead to serious personal injury and other accidents.. If you have any questions about the generator, please contact your dealer. E CAUTIOUS As long as following the instructions in this manual, the generators are safe and reliable. -
Page 10: Parts Identification
4. PARTS IDENTIFICATION Control Panel 5. CHECK BEFORE OPERATION The generator should be placed on a flat ground, without debris around, and at least 1 meter away from buildings and other equipment. BE CAUTIOUS Be sure to check whether the generator is placed horizontally, and the engine is off. - Page 11 Check the Oil Level BE CAUTIOUS Use non-detergency oil or 2-stroke engine oil could shorten the engine life. Use a strong detergency, high-quality 4-stroke engine oil, which must meet or exceed US automobile manufacturer's requirements of the American Petroleum Institute classification SG, SF levels.
- Page 12 When the fuel level is too low, please add fuel to the required level. Never use a mixture of oil and gasoline or dirty gasoline. Prevent dirt, water into the fuel tank. Tighten the fuel cap after refueling.. WARNING Gasoline is extremely flammable and explosive under certain conditions. ...
-
Page 13: Start The Engine
Connect the Battery The battery inside the generator is disconnected. Connect the battery before you start the generator. NOTICE Due to the characteristics of the lead-acid battery, it may require you to charge it after the first use or long-term storage. It is recommended that connect the battery charger to the DC socket on control panel for charging. - Page 14 Pull the handle until your feel resistance, then pull the handle outward to start the generator. According to the ambient temperature, push the choke cable inward after the starting the generator. The lower the ambient temperature is, the slower the inward pushing is. The higher the ambient temperature is, the faster the inward pushing speed is.
-
Page 15: Operating The Generator
Working at high altitudes In high altitude areas, the air-fuel mix in a standard carburetor is relatively thick, so the engine operating performance will reduce, while the fuel consumption increases. At this point you can adjust the main jet on the carburetor (smaller), while adjusting the ratio-mixing screw, then you can change the performance of the engine in high altitude areas. - Page 16 Use of AC Power Connect the ground bolt. Start the engine in accordance with the “Start the Engine” requirements. Make sure the connected device is turned off, then connect the device to the generator. When the LCD is on, turn on the connected device. BE CAUTIOUS ...
- Page 17 When using the generator with a pure inductive load, the pure inductive load cannot exceed the rated power of the generator. The power can only run 40% to 75% of rated power on pure inductive load. Model FGHI7000R Rated Power (W) 6300 Frequency（Hz）...
- Page 18 Start the generator as the above instruction. Connect the charging cable to the generator DC socket and connect it to the battery terminal WARNING Connect the charging cable to the battery first, and then connect it to the generator. Disassembly must start from the generator side, which prevents sparks start beside the battery.
-
Page 19: Shut Off The Engine
Oil alert system The oil alert system is designed to prevent damage to the engine due to insufficient oil. The oil alarm system automatically shuts down the engine before the oil in the crankcase drops to the safety line (although the start switch remains in the "on" position). After the engine alarm system shuts down the engine, if the user tries to start the engine again, the oil alert indicator (red) will flash briefly and the engine will no longer operate. -
Page 20: Maintenance
Turn the fuel switch to “OFF” position. When not using the generator for a long time, please turn off the generator. 9. MAINTENANCE Maintenance and adjustment schedules are developed to keep the generator in the best working condition. WARNING ... - Page 21 Oil Change When the engine is warm, you can quickly and completely discharge the oil. BE CAUTIOUS Make sure that the engine switch and the fuel switch are off before draining the oil. Loosen the oil drain screw, drain the oil. ...
- Page 22 WARNING Do not use gasoline or low-ignition solvents to clean the generators because they are flammable and explosive under certain conditions. Check the air filter core to make sure it's clean and the performance is normal. Remove the side maintenance cover screws, open the side maintenance cover. ...
- Page 23 If the insulator has been ruptured, it must be scrapped. If you want to use the spark plug again, use a brush to clean the spark plug. Measure the spark plug clearance with a feeler gauge, and the spark plug clearance should be 0.6-0.7mm (0.024-0.028 in) ...
-
Page 24: Transportation/Warehousing
10. TRANSPORTATION/WAREHOUSING To prevent fuel leakage during transport or temporary storage, turn off the oil switch and place the generator in a location where no fuel leaks. WARNING When transporting the generator： Do not fill too much fuel into fuel tank. (There should be no fuel in the filler). ... -
Page 25: Troubleshooting
11. TROUBLESHOOTING Cannot start the engine Is there any fuel in the tank？ Refuel 有 否 Is the start switch & fuel switch on? Turn the switch to “ON” position 是 否 Does the engine has enough oil？ Add recommended oil 是... - Page 26 Connected device does not work Is the output indicator ON or OFF? Return the generator to an authorized Is overload indicator ON? dealer for further assistance. Shut off the generator and wait until the overload indicator turns off, then start Does the connected device again or press the reset button to restart work?
-
Page 27: Specifications
12. SPECIFICATIONS Engine Model No. XG-190F Engine type 4-stroke, single cylinder, OHV Displacement( CC) 406cc Rated speed 3600/min Compression ratio Starting system Electric, Recoil and Remote Fuel Volume (L) Lube. Oil capacity (L) 1.1 L Spark plug F7RTC Sound pressure level: L 74.7 dB(A), K = 0.93dB(A) Sound power level L 95.7 dB(A), K = 0.93dB(A) -
Page 28: Circuit Diagram
13. CIRCUIT DIAGRAM... -
Page 29: Declaration Of Conformity
14. CE DECLARATION OF CONFORMITY BUILDER SAS 32 rue Aristide Bergès - Z.I. du Casque - 31270 Cugnaux - France Tel : +33 (0)5.34.502.502 Fax : +33 (0)5.34.502.503 States that the designated below machine: Product: Petrol Inverter generator Model: FGHI7000 R Serial number:20220512848-20220512865 is in confirmity with the essential requirements and other relavant provisions of the applicable European Directives,based on the application of European harmonized standerds.Any... -
Page 30: Warranty
15. WARRANTY WARRANTY The manufacturer guarantees the product against defects in material and workmanship for a period of 2 years from the date of the original purchase. The warranty only applies if the product is for household use. The warranty does not cover breakdowns due to normal wear and tear. The manufacturer agrees to replace parts identifed as defective by the designated distributor. -
Page 31: Product Failure
16. PRODUCT FAILURE WHAT TO DO IF MY MACHINE BREAKS DOWN? If you bought your product in a store: a) Empty the fuel tank if your product has one. b) Make sure that your machine is complete with all accessories supplied, and clean! If this is not the case, the repairer will refuse the machine. -
Page 32: Warranty Exclusions
17. WARRANTY EXCLUSIONS THE WARRANTY DOES NOT COVER: • Start-up and setting up of the product. • Damage resulting from normal wear and tear of the product. • Damage resulting from improper use of the product. • Damage resulting from assembly or start-up not in accordance with the user manual. •... - Page 33 BUILDER SAS 32 rue Aristide Bergès - Z.I. du Casque - 31270 Cugnaux - France MADE IN PRC...