Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Sentera Controls LT
Summary of Contents for Sentera Controls LT
- Page 1 ELECTRONIC FAN SPEED CONTROLLER Mounting and operating instructions...
-
Page 2: Table Of Contents
PRODUCT DESCRIPTION ARTICLE CODES INTENDED AREA OF USE TECHNICAL DATA STANDARDS OPERATIONAL DIAGRAMS WIRING AND CONNECTIONS MOUNTING INSTRUCTIONS IN STEPS OPERATING INSTRUCTIONS TRANSPORT AND STORAGE WARRANTY AND RESTRICTIONS MAINTENANCE MIW-LT-EN-000 - 17 / 01 / 2024 2 - 80 www.sentera.eu... -
Page 3: Safety And Precautions
If you have any further questions, please contact your technical support or consult a professional. MIW-LT-EN-000 - 17 / 01 / 2024 3 - 80 www.sentera.eu back to the table of contents... -
Page 4: Product Description
CONTROLLER PRODUCT DESCRIPTION The LT speed controller provides manual control of the rotational speed of voltage controllable (230 VAC / 50 Hz) motors by varying the supply voltage through phase angle control. Several motors can be connected as long as the current limit is not exceeded. -
Page 5: Operational Diagrams
NO T E output (). In this case, do not connect the power supply to . MOUNTING INSTRUCTIONS IN STEPS Before you start mounting the LT speed controller, read carefully “Safety and Precautions”. Then proceed with the following mounting steps: ATTENTION... - Page 6 Disconnect the mains supply. Mount the external enclosure to the wall by dowels and screws (not delivered). Consider the mounting dimensions shown in Fig. 3. MIW-LT-EN-000 - 17 / 01 / 2024 6 - 80 www.sentera.eu back to the table of contents...
-
Page 7: Operating Instructions
Replace the fuse. Mount all the parts back in place. ATTENTION Use only fuses with type and rating specified above; otherwise, loss of warranty will ensue. MIW-LT-EN-000 - 17 / 01 / 2024 7 - 80 www.sentera.eu back to the table of contents... -
Page 8: Transport And Storage
In case of heavy pollution, clean with a non-aggressive product. In these circumstances the unit should be disconnected from the supply. Pay attention that no fluids enter the unit. Only reconnect it to the supply when it is completely dry. MIW-LT-EN-000 - 17 / 01 / 2024 8 - 80 www.sentera.eu...
Need help?
Do you have a question about the LT and is the answer not in the manual?
Questions and answers