Subscribe to Our Youtube Channel
Related Manuals for Sentera Controls GTT-1
Summary of Contents for Sentera Controls GTT-1
- Page 1 GTT-1 TEMPERATURE BASED FAN SPEED CONTROLLER POWER RANGE: 3,5—7,5 A Mounting and operating instructions...
-
Page 2: Table Of Contents
ARTICLE CODES INTENDED AREA OF USE TECHNICAL DATA STANDARDS OPERATIONAL DIAGRAM WIRING AND CONNECTIONS MOUNTING INSTRUCTIONS IN STEPS OPERATING INSTRUCTIONS VERIFICATION OF INSTALLATION TRANSPORT AND STORAGE WARRANTY AND RESTRICTIONS MAINTENANCE MIW-GTT-1-35-75-L22-EN-000 - 07 / 11 / 2018 2 - 8 www.sentera.eu... -
Page 3: Safety And Precautions
In case there are any questions that are not answered, please contact our technical support or consult a professional. MIW-GTT-1-35-75-L22-EN-000 - 07 / 11 / 2018 3 - 8 www.sentera.eu... -
Page 4: Product Description
■ Protection standard: IP54 (according to EN 60529) ■ Operating ambient conditions: Temperature: 0—35 °C ► ► Rel. humidity: 5—95 % rH (non-condensing) MIW-GTT-1-35-75-L22-EN-000 - 07 / 11 / 2018 4 - 8 www.sentera.eu back to the table of contents... -
Page 5: Standards
Caution: When choosing a controller it is important to know the maximum current on the taps. Make sure you have chosen the right controller. You can take the indicated rated maximum current from each transformer tap. ATTENTION Make sure you use cables with an appropriate diameter to connect the fans to the GTT-1 controller. MIW-GTT-1-35-75-L22-EN-000 - 07 / 11 / 2018 5 - 8 www.sentera.eu... -
Page 6: Mounting Instructions In Steps
The two Schuko sockets are intended only for connecting motors / fans. The total NOTE load connected to both sockets must not exceed the rated maximum current of the GTT-1 controller. Do not plug other types of electric appliances into them! MIW-GTT-1-35-75-L22-EN-000 - 07 / 11 / 2018 6 - 8... -
Page 7: Operating Instructions
Install the PT500 temperature probe in an appropriate zone in order to measure the relevant ambient temperature. Plug the GTT-1 into the mains electricity network. Select the operating mode by turning the control switch / knob on the right to the relevant position (Fig. -
Page 8: Verification Of Installation
In case of heavy pollution, clean with a non-aggressive product. In these circumstances the unit should be disconnected from the supply. Pay attention that no fluids enter the unit. Only reconnect it to the supply when it is completely dry. MIW-GTT-1-35-75-L22-EN-000 - 07 / 11 / 2018 8 - 8 www.sentera.eu...
Need help?
Do you have a question about the GTT-1 and is the answer not in the manual?
Questions and answers