Table of Contents
Advertisement
Installing the server door (tower model)
The following illustration shows how to install the door on the tower model server.
Complete the following steps to install the server door:
1. Set the door on the bottom hinge.
2. Locate the flange on the top edge of the door.
3. Press the flange downward while pressing the top of the door toward the server,
4. Continue with "Cabling the server" on page 40.
Flange
until the flange connects with the top hinge. Release the flange.
Attention:
Be sure to maintain a clearance of at least 100 mm (4 inches) on
the front and rear of the server to allow for air circulation.
Door
Chapter 2. Installing options
37
Advertisement
Table of Contents
