Table of Contents
Advertisement
8/12/22, 2:53 PM
Firmware Updates
There are two ways to update the printer rmware:
Update Installer
Through the 3D Sprint interface
The following sections describe these processes.
Update Printer Firmware via Update Installer
Whenever a new rmware le is released for the printer, a desktop installation le will be posted in the
printer website. Follow the instructions below to download and install this update.
NOTE: Both your personal computer and the printer must be on the same network to update the printer's rmware using this method.
The update cannot be installed during printing.
CAUTION: For users on rmware 1.1.1, it is recommended to instead update rmware via
1. Visit the
Software Downloads
Network Installation.
2. Locate the downloaded zip le on your PC. Unzip the folder and open the
Figure_4_Update_Installer.exe
NOTE: You may receive a warning about opening a le from an unknown publisher. This is
normal. Tell the window to "open anyway."
ru.infocenter.3dsystems.com/figure4jewelry/print/book/export/html/526
Proxy Toggle
A
IP Address
- Public IP address of printer
B
Port
- Port printer is using for public connection
C
IP Address
- Proxy connection IP address
D
Port
- Port printer is using for proxy connection
E
Save
- This will become an active button when changes are made to settings.
F
page and download the Latest Firmware Installer for
le. You will see the screen at the right.
Руководство пользователя
- Turns the proxy connection on/off
Software Downloads
section of the
3D
Sprint.
52/120
Advertisement
Table of Contents
