Program Recording; Video Monitor Function - Telestar SATPLUS 4 Operating Instructions Manual

9. SPECIAL FUNCTIONS

9.4 Program recording

You can record a running radio or TV program onto a connected USB data carrier.
To do this, press the F1 button during a running program. To stop the recording, press the EXIT button and
confirm the prompt with Yes.

9.5 Video monitor function

You can use the device as a video monitor.
For example, you can use the device to align a surveillance camera or check an HDMI or analog video
signal.
To do this, connect an AV cable or an HDMI cable from a video source to the AV or HDMI input of the
device and connect the cable to an audio/video source.
The RCA-BNC adapter included in the scope of delivery allows you to adapt the plug connection if
required.
> Press the AVS button to activate the HDMI input of the device.
> Press the AVS button twice to activate the analog audio/VIdeo input.
If you want to set up a surveillance camera or other video output device with 12 volt operating voltage, you
can use the DC power cable included in the scope of delivery. This allows the video device to be
supplied with operating voltage via the SATPLUS 4
9.6 Perform optical measurement
DANGER!
Incorrect commissioning of the appliance can lead to serious injury or damage to the appliance.
> The device may only be operated by personnel who have received the necessary training in
handling electrical and optical devices and who have been instructed in the use of lasers.
> If prescribed by the hazard class, use approved eye protection devices.
> Do not point the fiber optic cable at other persons.
> If eye protection is required for the work to be carried out, use only approved
protective equipment.
> Cover all unfinished ends that correspond to a performance above hazard class 1
individually or together when no work is being carried out on them.
> Only use approved covers or cover materials.
31
EN
TELESTAR SATPLUS 4