Sat Measuring Range - Telestar SATPLUS 4 Operating Instructions Manual

6. SAT- MEASURING RANGE
6.1 DVB-S/S2 default setting
The device can be used to optimally align the satellite antenna. In addition, the following setting can be
used to perform a search to save programs for the satellite to be received.
> Connect the antenna cable to the measuring receiver at the LNB input.
> Select the Satellite menu item in the main menu and confirm with OK.
Satellite
> In the Satellite line, select the satellite position to which the satellite system is to be aligned or on
which a measurement is to be carried out.
LNB frequency
> In the LNB line, you can use the left/right arrow buttons to select the LNB with which the
satellite position is to be received.
The standard setting is Universal (9750-10600) The device automatically switches between Ku-
LOW and Ku-HIGH when RF input is made. The threshold for switching to the high band is 11.7
GHz. After entering the transponder frequency, the device issues the corresponding DiSEqC
or 22kHz switching commands.
Transponder
> Select the transponder on which the receiver should receive a signal from the selected satellite.
Frequency
> You can change the frequency of the selected transponder if required. Enter the frequency in this line
using the numeric keypad. To accept the change, press the blue button (SYS).
Symbol rate
> To adjust the symbol rate if necessary, switch to the Symbol rate line and enter the value using the
numeric keypad.
Polarization
> If required, switch between horizontal (H/V LED red) and vertical (H/V LED green) here.
22K
> The measuring receiver controls a connected LNB or a multi-switch via the conventional 14/18 V
- 22 kHz control (max. 4 SAT IF levels) or with DiSEqC control. The supply delivers a maximum
of 500 mA. With the LNB setting Universal (9750 - 10600), the 22 kHz setting cannot be changed.
15
TELESTAR SATPLUS 4