DAYLIFF SMARTCON 2 Installation & Operating Manual page 17

4.7.2 Water Transfer Mode
Function switch setting
Fig 17: Water Transfer Mode Setting and Display
Operation:
Normal Water Demand
Fig 18 and 19 When the delivery tank water level is:
Ÿ Lower than Probe 1(float switch A: Down level), the controller will only run one
pump.
Ÿ Reaches Probe 4 (float switch A: Up level), the single pump stops running.
Ÿ Varies from Probe 1 & Probe 4 (float switch A: Down level Up level Down level), the
controller will alternate between the two pumps automatically.
Extra Water Demand
Ÿ Decreases to Probe 2 (Float Switch B: Down level), with a single pump running, the
controller will run both pumps together until the water level reaches Probe 4 (Float
Switch A & B: Up level).
Fig 18: Water Transfer Mode with Delivery Tank Water Level Probes
LCD display
4 13