Invacare® SB® 755
1.
Lift the leg section of the mattress support to free t he
base.
2.
Fit the crossbar into place and tighten the screws.
3.
When properly installed, the leg section of the m attress
support leans on the crossbar.
3.12 Mattress support extension
For patients, taller than two meters it is recommended to
extend the bed with a mattress support extension.
WARNING!
Risk of injury
The user can fall out of bed, get trapped or
suffocated.
— Always extend the mattress when extending
bed.
— There must be a distance of more than 2,5 c m,
between the bed end and the mattress b ow, to
avoid entrapment of fingers.
WARNING!
Risk of injury
The user can get hit by the lifting pole or fall out of
bed.
— Always make sure to tighten the screws for t he
mattress support extension.
14
The bed can be extended 5 or 10 cm in both ends of the b ed –
to a maximum extension of 20 cm.
1. Dismount the side rail(s) and lifting pole (bed head e nd).
2. Extend the bed in the foot end.
a. Loosen the screws A on the bed end attachments.
b. Pull out the bed end attachments B 5 or 10 cm, and
re-tighten both screws A.
c. Loosen the screws C on the mattress bow D
and pull it out to match the extension. Make
sure there is at least 2,5 cm between the
mattress bow and the bed end.
3. Extend the bed in the head end
a. Loosen the screws A on the side tube of the m attress
support frame.
b. Pull out the cross tube B 5 or 10 cm, and re-tighten
both screws A.
4. Replace the mattress or put in a fitting mattress piece.
5. Mount the side rail(s) and lifting pole (bed head end).
Loose mattress pieces should always be fitted in t he
foot end of the bed.
3.13 Bumper wheels on Emma and
Piggy bed ends
Bumper wheels cannot be mounted onto other bed
ends.
The bumper wheels can be mounted in two different ways.
See illustrations.
1577126-J