Viewing Step Count Data; Recording Your Current Location (Location Memory); Checking The Distance And Bearing To A - Casio 5602 Operation Manual

Viewing Step Count Data

PRO TREK Connected can be used to view
the information below, which is measured by
the watch.
Your step count and physical exertion over
●
the past 24 hours
Weekly number of steps, calories burned
●
1. Y
Tap the "PRO TREK Connected" icon.
2. X
Hold down (B) for at least two seconds
until the second hand points to [R] twice.
When a connection is established
between the watch and phone, [APP] will
change to [OK], and the second hand will
move from [R] to [C].
Trying to connect
3. Y
Follow the instructions on the screen to
display pedometer data.
Note
You can also use PRO TREK
●
Connected to specify a daily step
target.
Though the step count is displayed on
●
the watch in real time, PRO TREK
Connected displays step counts at the
time when a connection is established
between the watch and phone.
Because of this, the step counts
displayed by PRO TREK Connected
may be different from those displayed
by the watch.
Operation Guide 5602
Recording Your Current
Location (Location Memory)
You can use PRO TREK Connected to record
current location information.
1. Y
Tap the "PRO TREK Connected" icon.
2. X
Enter the Compass Mode.
Navigating Between Modes
l
3. X
Hold (A) for at least five seconds until
[MEMORY] starts to flash. Release when
the second hand points to [R] twice.
If location information is successfully
acquired after a connection is established
between the watch and phone,
[MEMORY] will change to [OK], and the
second hand will move from [R] to [C].
Connection
successful
[ERR] will appear on the display if
●
connection fails for some reason.
[FAILED]
●
sequence if location information
acquisition fails for some reason.
Trying to connect
4. Y
Perform the operation shown on the
phone screen to view the Location
Memory information record.
You can have only one location record
●
in memory. Saving location information
while there is already a location record
in memory will overwrite the existing
record with the new information.
Note
If there is location information stored in
●
Location Memory, you can use
Location Indicator to check the
distance and bearing to the stored
location.
Checking the Distance and
l
Bearing to a Location Memory
Point (Location Indicator)
[POSITION] will appear in
n
Connection
successful
Checking the Distance and
Bearing to a Location
Memory Point (Location
Indicator)
The watch acquires current location
information from the phone, and then displays
the bearing and distance from your current
location to the location recorded in Location
Memory.
Recording Your Current Location (Location
l
Memory)
Memory point
Bearing to memory point
Distance to memory point
Important!
Note that PRO TREK Connected
●
operation is disabled while Location
Indicator is in use.
1. Y
Tap the "PRO TREK Connected" icon.
2. X
Enter the Compass Mode.
Navigating Between Modes
l
12