Customizing the
Timekeeping Mode Screen
You can use G-SHOCK Connected to
rearrange display items on the Timekeeping
Mode, and to add or remove items.
Important!
Note that you cannot use watch
●
operations to configure display item
settings. Use G-SHOCK Connected to
configure settings.
The items below can be displayed.
Day of the week, month, day
●
Year, month, day *
●
Barometric pressure graph, month, day
●
Barometric Pressure Graph *
●
Hour, minute, second
●
World Time hour, minute *
●
Step count
●
Home Time City sunrise/sunset times *
●
* Item that can be added using G-SHOCK
Connected. These items are not displayed
under initial default settings.
Operation Guide 5594
1.
Y Tap the "G-SHOCK Connected" icon.
2.
X Hold down (B) for at least two seconds
until the second hand points to [R] twice.
When a connection is established
between the watch and phone, [APP] will
change to [OK], and the second hand will
move from [R] to [C].
Trying to connect
3.
Y Perform the operations shown on the
phone screen to configure mode settings.
Viewing Step Count Data
G-SHOCK Connected can be used to view the
information below, which is measured by the
watch.
Your step count and physical exertion over
●
the past 24 hours
Weekly number of steps, calories burned
●
1.
Y Tap the "G-SHOCK Connected" icon.
2.
X Hold down (B) for at least two seconds
until the second hand points to [R] twice.
When a connection is established
between the watch and phone, [APP] will
change to [OK], and the second hand will
move from [R] to [C].
Trying to connect
3.
Y Follow the instructions on the screen to
display pedometer data.
Note
You can also use G-SHOCK
●
Connected to specify a daily step
target.
Though the step count is displayed on
●
the watch in real time, G-SHOCK
Connected displays step counts at the
time when a connection is established
between the watch and phone.
Because of this, the step counts
displayed by G-SHOCK Connected
may be different from those displayed
by the watch.
Recording Your Current
Location (Location Memory)
You can use G-SHOCK Connected to record
current location information.
1.
Y Tap the "G-SHOCK Connected" icon.
2.
X Enter the Timekeeping Mode or
Compass Mode.
Connection
Navigating Between Modes
successful
l
3.
X Hold down (C) for at least five seconds
until [MEMORY] starts to flash. Release
the button when the second hand points
to [R] twice.
If location information is successfully
acquired after a connection is established
between the watch and phone,
[MEMORY] will change to [OK], and the
second hand will move from [R] to [C].
[ERR] will appear on the display if
●
connection fails for some reason.
[FAILED] n [POSITION] will appear in
●
sequence if location information
acquisition fails for some reason.
Trying to connect
4.
Y Perform the operation shown on the
phone screen to view the Location
Memory information record.
Connection
successful
You can have only one location record
●
in memory. Saving location information
while there is already a location record
in memory will overwrite the existing
record with the new information.
Note
If there is location information stored in
●
Location Memory, you can use
Location Indicator to check the
distance and bearing to the stored
location.
Checking the Distance and Bearing
l
to a Location Memory Point
(Location Indicator)
Connection
successful
11