Table of Contents
Advertisement
Installing the Media Converter
Caution
All Countries: Install this product in accordance with local and
National Electric Codes.
Installing the Media Converter
The following procedure explains how to install an AT-MC100 Series Media
Converter.
To install the media converter, perform the following procedure:
1.
Remove all equipment from the package and store the packaging material
in a safe place.
Note
Do not remove the dust cover from the fiber optic port until you are
ready to connect the fiber optic cable. Dust contamination can adversely
impact the operating performance of the port on the media converter.
2.
If you are installing the media converter in an AT-MCR12 chassis, refer to
the chassis's installation guide for instructions on how to install the unit,
then proceed to Step 5.
3.
Place the media converter on a flat, secure surface (such as a desk or
table) leaving ample space around the unit for ventilation.
4.
Attach the four protective rubber feet to the bottom of the media
converter. See Figure 5. Do not attach the protective feet if you are
installing the unit in an AT-MCR12 chassis.
12
!
12
Figure 5 Attaching the Protective Feet
Advertisement
Table of Contents
