Table of Contents
Advertisement
Electrical Safety and Emission Compliance
Standards: This product meets the following standards.
Declaration Of Conformity
Manufacture Name:
Manufacture Address:
Manufacture Telephone:
Declares that the Product:
Model Numbers:
This product complies with FCC Part 15B, Class B Limits:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device must not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Radiated Energy
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device pursuant to Part 15 of FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance
with instructions, may cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on;
the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes and modifications not expressly approved by the manufacturer or
registrant of this equipment can void your authority to operate this
equipment under Federal Communications Commission rules.
Warning: This product requires only Category 3, 4, or 5 shielded twisted-
pair cable for all 10 Mbps RJ-45 connections, and Category 5 shielded
twisted-pair for all 100 Mbps RJ-45 connections to comply with Class B
emission limits. If not used with shielded cables, this product may cause
radio interference in which case the user may be required to take adequate
measures to reduce interference levels.
U.S. Federal Communications Commission
Allied Telesyn, Inc.
960 Stewart Drive, Suite B
Sunnyvale, CA 94086 USA
408-730-0950
Fast Ethernet Media Converters
AT-MC101XL, AT-MC102XL,
AT-MC103XL, AT-MC103LH,
AT-MC103SC/FS3,
AT-MC103ST/FS3,
AT-MC103SC/FS4,
AT-MC103ST/FS4
iii
Advertisement
Table of Contents
