Summary of Contents for Sunny Health & Fitness SF-E905 SMART
Page 1
SMART MAGNETIC ELLIPTICAL SF-E905 SMART USER MANUAL IMPORTANT! Please retain owner’s manual for maintenance and adjustment instructions. Your satisfaction is very important to us, PLEASE DO NOT RETURN UNTIL YOU HAVE CONTACTED US: support@sunnyhealthfitness.com or 1-877-90SUNNY (877-907-8669).
IMPORTANT SAFETY INFORMATION We thank you for choosing our product. To ensure your safety and health, please use this equipment correctly. It is important to read this entire manual before assembling and using the equipment. Safe and effective use can only be achieved if the equipment is assembled, maintained, and used properly.
PRE-ASSEMBLY CHECK LIST Before you start to assemble, please make sure all parts are included. SMART MAGNETIC ELLIPTICAL SF-E905 SMART USER MANUAL IMPORTANT! Please retain owner’s manual for maintenance and adjustment instructions. Your satisfaction is very important to us, PLEASE DO NOT RETURN UNTIL YOU HAVE CONTACTED US: support@sunnyhealthfitness.com or 1-877-90SUNNY (877-907-8669).
Page 5
ASSEMBLY INSTRUCTIONS We value your experience using Sunny Health and Fitness products. For assistance with parts or troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY (877-907-8669). STEP 1: Remove 2 Plastic Tubes (No. H) from the Main Frame (No. 1). Attach the Front Stabilizer (No.
Page 6
We value your experience using Sunny Health and Fitness products. For assistance with parts or troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY (877-907-8669). STEP 3: Remove 2 Wave Washers (No. 96), 2 Hex Bolts (No. 25) and 2 Flat Washers (No. 26) from the long axle of the Handlebar Post (No.
Page 7
We value your experience using Sunny Health and Fitness products. For assistance with parts or troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY (877-907-8669). STEP 4: Secure the Left & Right Pedals (No. 27L & No. 27R) to the Left & Right Pedal Support Tubes (No.
Page 8
We value your experience using Sunny Health and Fitness products. For assistance with parts or troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY (877-907-8669). STEP 6: Remove 4 Phillips Screws (No. 29) from the Meter (No. 38) with Spanner (No. 103). Plug the Pulse Sensor Wire (No.
TROUBLESHOOTING 1. If you find there is no difference between tension level 1 to level 8, please check the connection of the tension cable. Please see Diagram A under STEP 2. 2. If the meter does not show numbers correctly, please check the batteries. If the meter does not count the speed and time, please check the connections of Upper Sensor Wire (No.
ADJUSTMENT GUIDE ADJUSTING THE TENSION Adjust the tension by rotating the Tension Controller (No. 10a) clockwise to increase the level of resistance. Rotate the Tension Controller (No. 10a) counter-clockwise to decrease the level of resistance. Tension levels are set at Level 1 being the lowest and Level 8 being the highest.
BATTERY INSTALLATION & REPLACEMENT Battery Battery Cover BATTERY INSTALLATION 1. Take out 2 AAA batteries from meter box. 2. Press the buckle of battery cover on the Meter (No. 38), then remove battery cover. 3. Install 2 AAA batteries into the battery case on the back of the Meter (No. 38). Pay attention to the battery + and –...
Page 12
EXERCISE METER ■MODE KEY FUNCTION This key lets you select and lock on to a particular function you want. SCAN→TIME→SPD (SPEED)→DIST (DISTANCE)→CAL (CALORIES)→ODO (TOTAL DISTANCE)→CNT (COUNT)→SPM →PULSE Press and hold for 3 seconds to reset all the values, except ODO (TOTAL DISTANCE), to zero when Bluetooth is not connected.
2. After exercise resumes, the wireless heart rate icon will flash. If the heart rate monitor is not connected within 1 minute, the wireless heart rate icon will turn off. 3. When the meter wakes from sleep mode, the wireless heart rate icon will flash. If the heart rate monitor is not connected within 1 minute, the wireless heart rate icon will turn off.
PARTS LIST Description Spec. Qty. Description Spec. Qty. Main Frame Round End Cap Φ28X1.5 Front Stabilizer Pulse Sensor Wire 600mm Rear Stabilizer Spherical Cap Φ25X1.5 End Cap Φ50X1.5 Mushroom Cap Φ28.6X1.5 Leveler Cap Φ50X1.5 Left Hinge Bolt Φ16X85 Carriage Bolt M10XL57 Right Hinge Bolt Φ16X85...
Page 16
Description Spec. Qty. Description Spec. Qty. Belt Cover Plug Allen Wrench Wave Washer Φ20XΦ28X0.6 Spanner S13,S14,S15 Phillips Screw ST5X20 Crank Cover Round Plug 105L Left Belt Cover Spanner S13,S14 105R Right Belt Cover Spanner S17,S19 Plug Φ13X1.5 Allen Wrench Version: 1.1...