Intended Use; Before Installation, Re-Installation, Cleaning, Or Troubleshooting; Before Start-Up; During Operation - Linak DESKLINE Desk Frame 2 User Manual

Intended use

This product is intended for use indoors in household and commercial usage areas�
Do not use outdoors or in wet areas�

Before installation, re-installation, cleaning, or troubleshooting

• Stop the system�
• Unplug the mains cable�
• Relieve the system of any loads, which may be released during the work�
• Review the assembly instructions to confirm that the appropriate critical components and accessories are
being used with this product�

Before start-up

• Make sure that the system has been installed as instructed in this User Manual�
• Make sure that the voltage of the system matches the mains voltage before connecting the system to the
mains�
• Always use the supplied mains cable�

During operation

• If the system makes unusual noise or smells, unplug the mains cable immediately�
• Observe the maximum lifting force/self-lock (per frame; load - including tabletop - equally distributed)
Column Desk type
T-desk
Three-part
C-desk
• Duty cycle: 5 %, max� 1 minute continuous use at full load followed by 19 minutes pause�
• Take care that the cables are not damaged�
CAUTION
Load on the desk
Risk of injury to persons and of malfunction
• Do not overload the frame�
• Place heavy load centrally on the desk�
• Do not use the desk as a work bench�
• Do not use the frame for lifting persons�
• Do not stand on the desk while it is driving up or down�
NOTICE
Duty cycle
Risk of malfunction
• Do not exceed the duty cycle�
Max. lifting force (N)
1600
1400
Self-lock (N) Bending moment
1200 Max� 200 Nm dynamic
DF2 | 6