Table of Contents
Advertisement
No.
Name
7
Driver's seat
Status of the driver's seat
belt status
belt buckle.
8
Accelerator po-
The percentage of the ac-
sition, percent-
tual position of the accel-
age relative to
erator to the driver's fully
full open posi-
depressed position.
tion
9
Revolutions
The revolutions per mi-
per minute (r/
nute of the engine's main
min)
crankshaft
10 Event power
The number of power cy-
cycle count
cles recorded in the ECU
that captures EDR data
since its initial use to the
occurrence of the event.
An example of a power
cycle is when the ignition
is switched from "off/
assist" mode to "on/run"
mode.
11 Event power
The number of power cy-
cycle count at
cles recorded in the ECU
retrieval
that captures EDR data
since its initial use until
the data retrieval. An ex-
ample of a power cycle is
when the ignition is
switched from "off/
assist" mode to "on/run"
mode.
12 Event data re-
Status flag of whether
cording com-
the event data is fully re-
plete status
corded and stored in the
ECU that records the EDR
data.
13 Time interval
If two events occur with-
between this
in 5 seconds, the time is
event and the
the elapsed time be-
last event
tween the start of event
X and the start of event
X-1.
14 with vehicle
The vehicle identification
identification
number (VIN) assigned by
number
the vehicle manufacturer.
15 ECU hardware
The ECU hardware num-
number for re-
ber in the vehicle that im-
cording EDR
plements the EDR re-
data
cording function.
218
Owner's manual
Description
No.
16 ECU serial
17 ECU software
Labels and plates
Vehicle safety certificates, labels, and plates con-
taining important data and information are in-
stalled in the engine compartment and certain
vehicle components.
– Do not remove or damage safety certificates,
labels, and plates. Always keep the graphics
and text on them legible.
– When replacing vehicle components with safe-
ty certificates, labels, or plates, the new parts
should be installed with identical information
by Volkswagen dealerships.
High voltage warning label
The high voltage warning label is located near
the bonnet lock and displays a high voltage
warning message for the vehicle's electrical sys-
tem.
Improper handling of the vehicle can easily lead
to accidents and serious or fatal injuries.
● Always observe the relevant traffic regula-
● Always follow the instructions in this man-
Improper handling and operation may damage
the vehicle.
● Always comply with relevant regulations.
● Always follow the instructions in this manual.
Name
The ECU serial number in
number for re-
the vehicle that imple-
cording EDR
ments the EDR recording
data
function.
The ECU software num-
number for re-
ber in the vehicle that im-
cording EDR
plements the EDR re-
data
cording function.
WARNING
tions.
ual.
NOTICE
Description
Advertisement
Table of Contents
