Table of Contents
Advertisement
Transporter 2020 ➤
Auxiliary heater - Edition 04.2020
2
General information
WARNING
If the vehicle has been converted by ABT e-Line, it is possible
that the repair instructions provided below are no longer valid.
•
In this case, the workshop manual in ELSA Pro under the
tab "Superstructures and modifications" provided by ABT e-
Line must be observed and applied.
⇒ "2.1 Type plates", page 4
⇒ "2.2 Starting conditions for auxiliary/supplementary heater",
page 4
⇒ "2.3 Rules for cleanliness when working on auxiliary/supple‐
mentary heater and fuel system", page 5
⇒ "2.4 Notes for vehicles with a start/stop system", page 5
2.1
Type plates
There are different types of type plates.
When the auxiliary heater is renewed, check the type plate and
the duplicate plate and replace as necessary.
Type plate on auxiliary/supplementary heaters
♦ The date of first use is entered on the lower part of manufac‐
turer's plate.
♦ The year the unit was first put into use must be entered on the
Genuine part manufacturer's plate.
Duplicate type plate for auxiliary/supplementary heaters
♦ In the engine compartment of the vehicle, there is a second
(duplicate) type plate attached to the right of the lock carrier
(when looking in direction of travel). If there is any doubt con‐
cerning the type of the auxiliary/supplementary heater, always
observe the type plate attached directly to the auxiliary/sup‐
plementary heater.
2.2
Starting conditions for auxiliary/supple‐
mentary heater
♦ Engine type OK (diesel/petrol)
♦ Terminal 15 (ignition) on
♦ Engine speed >600 rpm
♦ Coolant temperature <69°C
♦ Ambient temperature <5 C
♦ Reserve fuel level not reached
4
Rep. gr.00 - Technical data
Hide quick links:
Advertisement
Table of Contents
