Table of Contents
Advertisement
Switching off the "Coming home" function
– After the set switch-off delay has elapsed, the
light will automatically turn off.
– Or: When one door or the rear door is open
about 30 seconds after "Coming home " func-
tion is switched on, the light will automatically
goes out.
– Or: Turn the headlight switch to position.
Enable the "Leaving home" function
– When the headlight switch is in position
and the rain/light sensor detects darkness, the
Coming Home lighting is switched on when
unlocking the vehicle.
Switching off the "Leaving home " function
– After the set switch-off delay has elapsed, the
light will automatically turn off.
– Or: Lock the vehicle.
– Or: Turn the headlight switch to position.
Ambient lighting in the exterior mirror
Ambient lights in the exterior mirror directly illu-
minate the area around the door when getting on
and off the vehicle. Switch on the ambient lights
when you unlock the vehicle or activate the
"Coming home" or "Leaving home" lighting func-
tions. If the vehicle is equipped with a light sen-
sor, the environmental lights in the exterior mir-
ror will be switched on only when the sensor per-
ceives the environmental darkness.
Headlight
Headlight range control
Fig. 69 Next to headlight switch: headlight range
adjustment knob
76
Owner's manual
Headlight range adjustment adjusts the headlight
beam to the appropriate position according to
the vehicle load, improving visibility without
blinding oncoming traffic
The headlamp lighting range can be adjusted on-
ly when the headlamp dipped beam is switched
on.
Headlight range control
Rotate adjustment knob
position according to vehicle load:
Knob po-
Vehicle load
sition
Front seats occupied and luggage
compartment empty.
All seats occupied and luggage com-
partment empty.
All seats occupied and luggage com-
partment fully loaded. Towing a trail-
er with a low drawbar load.
Only the driver seat occupied and
luggage compartment fully loaded.
Towing a trailer with maximum
drawbar load.
a)
The transition position of the regulator can also be used if the
vehicle load varies.
WARNING
Failure or malfunction in the headlight range
control can cause the headlights to dazzle or
distract other road users. This can cause acci-
dents and serious or fatal injuries.
● Be sure to adjust the headlamp correctly so
that it is always in the correct lighting state.
● Do not turn on headlight main beam or
headlight flasher if it may cause blinding ef-
fect to other vehicle drivers.
WARNING
Heavy objects in the vehicle can change the
ride height and cause the headlights to dazzle
and distract other road users. This can cause
accidents and serious or fatal injuries.
● Always adapt the light cone to the load level
of the vehicle to avoid dazzling other road
users.
.
→
to the following
1
a)
Advertisement
Table of Contents
