Table of Contents
Advertisement
– In this case, we should find out the reason why
the doors and windows cannot be closed
smoothly.
– Then try closing the doors and Windows again.
– If the closing process of doors and windows is
interrupted again, the roll-back function will
be disabled for a few seconds.
– If the door and window cannot be closed, the
window and window glass will stop at the
blocked position. If you pull up the button
again within a few seconds, the windows will
be closed without the roll-back function
WARNING
Closing electric windows without roll-back
function may hurt people inside the car.
● Be careful when closing doors and Windows.
● When closing doors and windows, make sure
that no one is within the lifting range of win-
dows and doors glass, especially when the
roll-back function does not work.
● Roll-back function can not protect the fin-
gers or other parts of the body at the win-
dow frame, beware of clamping!
The roll-back function also works when us-
ing the vehicle key to close doors with Easy
closing.
Troubleshooting
Single touch open and close function is
disabled
If the 12-volt vehicle battery is disconnected or
the battery runs out when the windows are not
completely closed, the single-touch function will
not work. You must restore the single-touch
function in the following ways.
– Switch on the ignition.
– Close all windows and doors.
– Pull up the button on the corresponding win-
dow and hold it there for a few seconds.
– Release the button, then pull the button up
again and hold it in the pull-up position. At this
point, the one-touch open and close function
is restored.
You can use the method described above to re-
store the single touch function of a window or
several windows at the same time.
62
Owner's manual
Close the windows without Roll-back function
– Try to close the window again by holding the
button for a few seconds. At this time, the
system for a small section of window glass
path to close the roll-back function!
– If the closing process lasts more than a few
seconds, the roll-back function reactivates. If
the window rises again or is blocked at anoth-
er place, the window will stop closing again
and automatically reopen.
– If the fault persists, go to a correspondingly
qualified workshop. Volkswagen recommends
.
→
using a Volkswagen dealership.
Sliding/tilting roof
Opening or closing the sliding/
tilting roo
Fig. 54 Interior roof: Button for sliding/tilting roof
Tilt, open, and close the sliding/tilting roof
– Tilting open sliding/tilting roof:When the sun-
roof is fully closed, press and hold the button
Fig. 54
→
quired position. Automatic operation: Click the
button to automatically run the sunroof to the
terminal position
sunroof to the terminal position.
– Close sliding/tilting roof: Press and hold the
button
until the sunroof reaches the de-
sired position. Automatic operation: Click the
button to automatically run the sunroof to the
terminal position
sunroof to the terminal position.
until the sunroof reaches the re-
to automatically run the
to automatically run the
Advertisement
Table of Contents
