Seat Belt-Tongue Assembly; Seat Belt-Buckle Bracket (Non-Myride Models Only); Seat Belt-Tongue Bracket; Hex-Head Bolt (1/2 X 1 Inch) - Toro 79487 Manual

4
Installing the Seat Belt
Non-MyRide Models Only
Parts needed for this procedure:
1 Seat belt-buckle assembly
1

Seat belt-tongue assembly

1

Seat belt-buckle bracket (non-MyRide models only)

1 Seat belt-tongue bracket (non-MyRide models only)
2

Hex-head bolt (1/2 x 1 inch)

6

Locknut (1/2 inch)

4

Carriage bolt (3/8 x 1 inch)

4

Locknut (3/8 inch)

Procedure
1. Assemble the seat belts by attaching the buckle
and tongue to the inside of the seat-belt brackets
using 2 hex-head bolts (1/2 x 1 inch) and 2
locknuts (1/2 inch) as shown in
1. Buckle
2. Locknut (1/2 inch)
3. Tongue
2. Install the buckle assembly from step
inside of the roll bar bracket using 2 carriage
bolts (3/8 x 1 inch) and 2 locknuts (3/8 inch) as
shown in Figure 10. Repeat on the other side for
the tongue assembly.
Figure 9.
Figure 9
4. Tongue bracket
5. Hex-head bolt (1/2 x 1
inch)
6. Buckle bracket
1
1. Carriage bolt (3/8 x 1 inch) 3. Locknut (3/8 inch)
2. Buckle assembly
5
Installing the Upper Roll
Bar
Parts needed for this procedure:
1

Upper roll bar

2

Bumper

2

Shoulder bolt

2

Wave washer

2

Latch-pin assembly

2 Locknut (1/2 inch)
g471783
Procedure
1. Install the rear tires as shown in
2. Lower the machine; refer to your machine
Operator's Manual.
to the
3. Lower or install the seat; refer to
the Machine (page
4. Locate the upper roll bar tube. Install 2 rubber
bumpers
6
Figure 10
Buckle assembly shown
3).
(Figure 11).
g472041
Figure 4.
1 Preparing